[ Upstream commit d05f7aff7a ]
Designate the RK806 PMIC on the Radxa ROCK 5A as the system power
controller, so the board shuts down properly on poweroff(8).
Fixes: 75fdcbc8f4 ("arm64: dts: rockchip: add PMIC to rock-5a")
Reviewed-by: Dragan Simic <dsimic@manjaro.org>
Signed-off-by: FUKAUMI Naoki <naoki@radxa.com>
Link: https://lore.kernel.org/r/20240612033523.37166-1-naoki@radxa.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Signed-off-by: Sasha Levin <sashal@kernel.org>
Enable USB2 (EHCI and OCHI mode) support for the Radxa ROCK 5 Model A.
This adds USB support for the on-board WLAN/BT chip, the two USB2
ports, the USB available from the 2x20 connector and the lower USB3
port (in USB2 mode).
The upper USB3 (further away from the PCB) uses the RK3588S USB TypeC
OTG controller for USB2 and USB3 and thus is not supported at all at
the moment.
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20230712165106.65603-5-sebastian.reichel@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
200MHz is the default rk3588 emmc max-frequency added in dtsi, so why
the board DT files are adding the same value explicitly?
Drop that unchanged property value.
Signed-off-by: Jagan Teki <jagan@edgeble.ai>
Link: https://lore.kernel.org/r/20230621064507.479891-1-jagan@edgeble.ai
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Enable ADC support for Rock 5A, which has the following ADC channels:
Channel 0 = Boot Mode Config
Channel 1 = Recovery Key
Channel 2 = PWM Fan
Channel 3 = Headphone Hook
Channel 4 = System Input Voltage
Channel 5 = Board ID Config
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20230710165228.105983-13-sebastian.reichel@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
I2C3 is routed to the Camera connector and I2C5 is routed to the LCD
connector. On I2C5 additionally there is an unpopulated footprint for
a HYM8563TS RTC.
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20230710165228.105983-12-sebastian.reichel@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Add analog audio support based on the Everest Semi ES8316 codec.
Note, that this currently does not support headphone plug events. The
Rock 5A uses a different headphone jack with a different logic to detect
a headphone plug. Unfortunately the detect GPIO is always low.
Downstream uses an ADC channel instead, but that is currently not
supported upstream.
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20230710165228.105983-9-sebastian.reichel@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
The RK8602 and RK8603 voltage regulators on the Rock 5A board provide
the power lines vdd_cpu_big0 and vdd_cpu_big1, respectively.
Add the necessary device tree nodes and bind them to the corresponding
CPU big core nodes.
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20230710165228.105983-5-sebastian.reichel@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
This adds PMIC support for the Radxa ROCK 5A
Co-developed-by: shengfei Xu <xsf@rock-chips.com>
Signed-off-by: shengfei Xu <xsf@rock-chips.com>
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20230710165228.105983-4-sebastian.reichel@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Add network PHY rx delay and change type to rgmii, so
that it is applied. This fixes packet loss when more
than a few packets are exchanged.
Fixes: d1824cf957 ("arm64: dts: rockchip: Add rock-5a board")
Signed-off-by: Lucas Tanure <lucas.tanure@collabora.com>
Link: https://lore.kernel.org/r/20230113130220.662194-1-lucas.tanure@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
In the previous version, the sdhci alias was set to mmc1: an artifact
leftover from the port from vendor kernel. Update the alias to mmc0 to
match the device's boot order.
Fixes: a4a8f1afb360 ("arm64: dts: rockchip: Add rock-5a board")
Signed-off-by: Christopher Obbard <chris.obbard@collabora.com>
Link: https://lore.kernel.org/r/20230110195352.272360-2-chris.obbard@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
Add board file for the RK3588s Rock 5A board. While the hardware
offers plenty of peripherals and connectivity this basic implementation
just handles things required to access eMMC, UART and Ethernet (i.e.
enough to successfully boot Linux).
Reviewed-by: Michael Riesch <michael.riesch@wolfvision.net>
Tested-by: Benjamin Gaignard <benjamin.gaignard@collabora.com>
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.com>
Link: https://lore.kernel.org/r/20230109155801.51642-7-sebastian.reichel@collabora.com
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
