37f9b2a6c0
A number of MDIO drivers make use of devm_mdiobus_alloc_size(). This is only available when CONFIG_MDIO_DEVRES is enabled. Add missing depends or selects, depending on if there are circular dependencies or not. This avoids linker errors, especially for randconfig builds. Signed-off-by: Andrew Lunn <andrew@lunn.ch> Reviewed-by: Jacob Keller <jacob.e.keller@intel.com> Link: https://lore.kernel.org/r/20230409150204.2346231-1-andrew@lunn.ch Signed-off-by: Jakub Kicinski <kuba@kernel.org>
1.9 KiB
SPDX-License-Identifier: GPL-2.0-only
Qualcomm network device configuration
config NET_VENDOR_QUALCOMM bool "Qualcomm devices" default y help If you have a network (Ethernet) card belonging to this class, say Y.
Note that the answer to this question doesn't directly affect the
kernel: saying N will just cause the configurator to skip all
the questions about Qualcomm cards. If you say Y, you will be asked
for your specific card in the following questions.
if NET_VENDOR_QUALCOMM
config QCA7000 tristate help This enables support for the Qualcomm Atheros QCA7000.
config QCA7000_SPI tristate "Qualcomm Atheros QCA7000 SPI support" select QCA7000 depends on SPI_MASTER && OF help This SPI protocol driver supports the Qualcomm Atheros QCA7000.
To compile this driver as a module, choose M here. The module
will be called qcaspi.
config QCA7000_UART tristate "Qualcomm Atheros QCA7000 UART support" select QCA7000 depends on SERIAL_DEV_BUS && OF help This UART protocol driver supports the Qualcomm Atheros QCA7000.
Currently the driver assumes these device UART settings:
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
To compile this driver as a module, choose M here. The module
will be called qcauart.
config QCOM_EMAC tristate "Qualcomm Technologies, Inc. EMAC Gigabit Ethernet support" depends on HAS_DMA && HAS_IOMEM select CRC32 select PHYLIB select MDIO_DEVRES help This driver supports the Qualcomm Technologies, Inc. Gigabit Ethernet Media Access Controller (EMAC). The controller supports IEEE 802.3-2002, half-duplex mode at 10/100 Mb/s, full-duplex mode at 10/100/1000Mb/s, Wake On LAN (WOL) for low power, Receive-Side Scaling (RSS), and IEEE 1588-2008 Precision Clock Synchronization Protocol.
source "drivers/net/ethernet/qualcomm/rmnet/Kconfig"
endif # NET_VENDOR_QUALCOMM