2.0 KiB
Booting OE Linux on the reMarkable2
The reMarkable2 is an e-ink reader using the iMX7 SoC.
This layer adds support for building the official kernel source and u-boot source for the rM2.
In order to build the images for the rM2 setup this layer and all dependencies and then run:
MACHINE = "imx7d-remarkable2" bitbake core-image-minimal -k
Booting the images
All of the steps here and in this repo aim for a temporary boot on the rM2. That is nothing should make any lasting changes to your rM2 and a simple reboot should restore any changes. That said, this could still break things, be careful.
To boot the images you first need to enter recovery mode.
There are steps for doing that available here: https://github.com/ddvk/remarkable2-recovery
In short you need to put a ~10K resistor between pin B8 and B12 on the USB-C breakout. You also want to connect the pogo pins to a USB break out board. As well as that you need to connect a FDTI UART receiver to the IN pin on the pogo pins.
Then power up the device. At which point you should see somthing like
hiddev0,hidraw5: USB HID v1.10 Device [Freescale SemiConductor Inc SE Blank ULT1] on usb-0000:00:14.0-9/input0
in dmeag.
Then you have to unplug the resistor and you can use imx_usb to download the images. Note that uuu should also work, but I haven't yet figured out how to load the images (not flash them)
Then add the following lines to the mx7_usb_work.conf file in imx_usb_loader, under hid,1024,0x910000,0x80000000,1G,0x00900000,0x20000
build/tmp/deploy/images/imx7d-remarkable2/zImage:load 0x80800000
build/tmp/deploy/images/imx7d-remarkable2/zero-sugar.dtb:load 0x83000000
build/tmp/deploy/images/imx7d-remarkable2/core-image-minimal-imx7d-remarkable2.ext4.gz.u-boot:load 0x83800000
build/tmp/deploy/images/imx7d-remarkable2/u-boot-dtb.imx:clear_dcd,plug,jump header
You can then run sudo ./imx_usb
You should see u-boot and Linux automatically boot on the rM2.